I installed the dual off camera ettl2 flash synch cord on a Canon 30D with two flashes mounted on a dual arm macro bracket. It was a bit heavy with all the gear, but the setup produced beautiful results. The problem is a small "locking" wire extending from the bottom of the connector becomes lodged in a threaded hole on the hotshoe. The connector will not come off. I even took it to a Canon factory authorized repair facility and they had to break the connector to remove it. If you don't mind a permanent setup, then this may work for you.
Buy Adorama Dual Off-Camera eTTL2 Flash Sync Cord for Canon EOS Cameras!
No comments:
Post a Comment